Chevrolet-Niva
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. The engine
5. Transmission
6. A running gear
7. A steering
7.1. Features of a design
7.2. Survey and steering check on the car
7.3. Check of a tension and adjustment of a belt of a drive of the pump of the hydraulic booster
7.4. Liquid replacement in hydrosystem of the amplifier of a steering
7.5. Replacement of a tank of hydrosystem of the amplifier of a steering
7.6. Prorolling of system of the hydraulic booster of a steering
7.7. Backlash adjustment in gearing of a roller with a worm
7.8. Removal and steering wheel installation
7.9. Replacement of shaft of a steering
7.10. Replacement of steering draughts
7.11. Removal and installation of the steering mechanism
7.12. Removal and installation of the pump of the hydraulic booster
7.13. Removal and installation of the pendular lever
7.14. Dismantling, дефектовка and assemblage of the pendular lever
7.15. Possible malfunctions of a steering without the hydraulic booster, their reasons and ways of elimination
7.16. Possible malfunctions of the hydraulic booster of a steering, their reason and ways of elimination
8. Brake system
9. An electric equipment
10. A body
11. Variants of execution of the car
12. Care of the car
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Appendices
 















7-3-proverka-natyazheniya-i-regulirovka-remnya-privoda-nasosa-gidrousilitelya.html

7.3. Check of a tension and adjustment of a belt of a drive of the pump of the hydraulic booster

It be required to you: keys «on 13» (two), small beards or an assembly shovel.
1. A belt tension check a branch deflection between pulleys of the pump of the hydraulic booster and a cranked shaft. The belt should adjoin densely to a pulley, however it is not necessary to suppose an excessive tension of a belt not to cause loading increase on pump bearings.
2. Ослабьте an inhaling of a nut of fastening of the pump to a tension lath.
3. With the help a small beard or an assembly shovel move the pump to the demanded party and achieve a demanded tension.

       NOTES
In need of belt replacement move the pump to the engine that it was possible to release a pulley of the pump and to replace a belt.
Pay attention to a wire of the gauge of position of a cranked shaft. Do not damage it at pump moving.
4. Tighten a nut of fastening of the pump to a tension lath.

«The previous page
7.2. Survey and steering check on the car
The following page»
7.4. Liquid replacement in hydrosystem of the amplifier of a steering