Chevrolet-Niva
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. The engine
5. Transmission
6. A running gear
7. A steering
7.1. Features of a design
7.2. Survey and steering check on the car
7.3. Check of a tension and adjustment of a belt of a drive of the pump of the hydraulic booster
7.4. Liquid replacement in hydrosystem of the amplifier of a steering
7.5. Replacement of a tank of hydrosystem of the amplifier of a steering
7.6. Prorolling of system of the hydraulic booster of a steering
7.7. Backlash adjustment in gearing of a roller with a worm
7.8. Removal and steering wheel installation
7.9. Replacement of shaft of a steering
7.10. Replacement of steering draughts
7.11. Removal and installation of the steering mechanism
7.12. Removal and installation of the pump of the hydraulic booster
7.13. Removal and installation of the pendular lever
7.14. Dismantling, дефектовка and assemblage of the pendular lever
7.15. Possible malfunctions of a steering without the hydraulic booster, their reasons and ways of elimination
7.16. Possible malfunctions of the hydraulic booster of a steering, their reason and ways of elimination
8. Brake system
9. An electric equipment
10. A body
11. Variants of execution of the car
12. Care of the car
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Appendices
 















7-6-prokachka-sistemy-gidrousilitelya-rulevogo-upravleniya.html

7.6. Prorolling of system of the hydraulic booster of a steering

Necessity for prorolling arises at hit in hydrosystem of air during repair work or at tightness loss at operation. A sign of presence of air in system is подклинивание a steering wheel at attempt of its sharp turn. Besides, the pump publishes the raised noise at the moment of steering wheel turn, and the liquid in a tank usually foams.
The key «on 8» is required to you.
1. At average position of a steering wheel start up the engine on 10-15 with.
2. Muffle the engine, without rotating a steering wheel.
3. Turn a steering wheel against the stop in one party.
4. Remove a protective cap from the valve of release of air.
5. Turn away the valve of release of air on the steering mechanism.
6. Without turning the valve, turn a wheel against the stop in other party. Thus the valve should leave air, and then a liquid.
7. Without touching a steering wheel, wrap the valve of release of air.
8. Having added in a tank oil, start up the engine and turn a steering wheel in both parties against the stop, without detaining him in extreme positions. After the occurrence termination in a tank of vials of air, stop the engine.
9. Add a liquid to level near to the top label on щупе tank stoppers.

«The previous page
7.5. Replacement of a tank of hydrosystem of the amplifier of a steering
The following page»
7.7. Backlash adjustment in gearing of a roller with a worm