Chevrolet-Niva
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. The engine
5. Transmission
6. A running gear
7. A steering
8. Brake system
9. An electric equipment
10. A body
10.1. Features of a design
10.2. Removal and installation of lobbies Lockers
10.3. Removal and installation of forward wings
10.4. Removal and installation of decorative overlays on forward wings and doors
10.5. Replacement of buffers
10.6. Removal and installation of facing of a radiator
10.7. Removal and cowl installation
10.8. Removal, installation and adjustment of the lock and a drive of the lock of a cowl
10.9. A back door
10.10. Forward doors
10.11. Back doors
10.12. Removal and installation of a cover of the hatch of a fuel tank
10.13. Seats
10.14. Removal of upholsteries of salon
10.15. Replacement of seat belts
10.16. Mirrors
10.17. Replacement противосолнечных peaks
10.18. Replacement of hand-rail
10.19. Removal and installation of facing of a tunnel of a floor
10.20. Removal and installation of the panel of fastening of a radio receiver
10.21. Removal and installation of the panel of devices
10.22. A heater
10.23. Replacement of a windscreen and glasses of a door of a back and боковины
10.24. Care of a body
10.25. Anticorrosive protection of a body
10.26. Possible malfunctions of a body, their reason and ways of elimination
11. Variants of execution of the car
12. Care of the car
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Appendices
 











10-19-snyatie-i-ustanovka-oblicovki-tonnelya-pola.html

10.19. Removal and installation of facing of a tunnel of a floor

Screw-drivers with a flat and crosswise edge be required to you.
1. Disconnect a wire from the plug "minus" of the storage battery.
2. Remove the panel of fastening of a radio receiver (Removal and installation of the panel of fastening of a radio receiver »see«).
3. Turn out four screws of fastening of a decorative overlay of the console and...
4.... Remove an overlay.
5. Turn out one screw of fastening of facing of a ware box outside and...
6.... Two screws from within.
7. Remove facing of a ware box.
8. Turn out screws of fastening of a ware box from within and...
9.... Sideways.
10. Disconnect wires from a plafond of illumination of a ware box.
11. Remove a ware box.
12. Remove handles of a transmission and a distributing box.
13. Turn out the screws located on perimetre of facing of a tunnel of a floor.
14. Lift the lever of a lay brake, take facing for a back part and...
15.... Remove it.
16. Establish the removed details in an order, the return to removal.

«The previous page
10.18. Replacement of hand-rail
The following page»
10.20. Removal and installation of the panel of fastening of a radio receiver