Chevrolet-Niva
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. The engine
5. Transmission
6. A running gear
7. A steering
8. Brake system
9. An electric equipment
10. A body
10.1. Features of a design
10.2. Removal and installation of lobbies Lockers
10.3. Removal and installation of forward wings
10.4. Removal and installation of decorative overlays on forward wings and doors
10.5. Replacement of buffers
10.6. Removal and installation of facing of a radiator
10.7. Removal and cowl installation
10.8. Removal, installation and adjustment of the lock and a drive of the lock of a cowl
10.9. A back door
10.10. Forward doors
10.11. Back doors
10.12. Removal and installation of a cover of the hatch of a fuel tank
10.13. Seats
10.14. Removal of upholsteries of salon
10.15. Replacement of seat belts
10.16. Mirrors
10.17. Replacement противосолнечных peaks
10.18. Replacement of hand-rail
10.19. Removal and installation of facing of a tunnel of a floor
10.20. Removal and installation of the panel of fastening of a radio receiver
10.21. Removal and installation of the panel of devices
10.22. A heater
10.23. Replacement of a windscreen and glasses of a door of a back and боковины
10.24. Care of a body
10.25. Anticorrosive protection of a body
10.26. Possible malfunctions of a body, their reason and ways of elimination
11. Variants of execution of the car
12. Care of the car
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Appendices
 















10-7-snyatie-i-ustanovka-kapota.html

10.7. Removal and cowl installation

It be required to you: a key «on 13», a screw-driver.

       GOOD ADVICE
To avoid traumas and not to damage a car detail, remove and establish a cowl with the assistant.
If will establish a former cowl, before its removal mark position of loops of a cowl on a body, having led round their felt-tip pen to keep adjustment of position of a cowl.


1. Open a cowl.
2. Disconnect a wire from the plug "minus" of the storage battery.
3. Separate колодку a plait of wires подкапотной lamps.
4. Take rubber plugs of a plait of wires from an aperture of the amplifier of a cowl.
5. Remove percussion caps of fastening of a heater of a cowl (on the left side).
6. Unbend a heater and remove the rubber plug of a plait of wires.
7. Enter колодку a plait of wires into an aperture of the amplifier of a cowl and...
8.... Remove a plait.
9. Disconnect submitting tube of a washer of a windscreen from a tee and...
10.... Lift the receiver.
11. If necessary by means of a screw-driver remove a collar of a plait of wires.
12. Turn away four nuts of fastening of loops of a cowl to a body and...
13.... Remove a cowl.
14. Establish a cowl in an order, the return to removal, on the labels put before removal.

«The previous page
10.6. Removal and installation of facing of a radiator
The following page»
10.8. Removal, installation and adjustment of the lock and a drive of the lock of a cowl