Chevrolet-Niva
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. The engine
5. Transmission
6. A running gear
7. A steering
8. Brake system
9. An electric equipment
10. A body
10.1. Features of a design
10.2. Removal and installation of lobbies Lockers
10.3. Removal and installation of forward wings
10.4. Removal and installation of decorative overlays on forward wings and doors
10.5. Replacement of buffers
10.6. Removal and installation of facing of a radiator
10.7. Removal and cowl installation
10.8. Removal, installation and adjustment of the lock and a drive of the lock of a cowl
10.9. A back door
10.10. Forward doors
10.11. Back doors
10.12. Removal and installation of a cover of the hatch of a fuel tank
10.13. Seats
10.14. Removal of upholsteries of salon
10.15. Replacement of seat belts
10.16. Mirrors
10.17. Replacement противосолнечных peaks
10.18. Replacement of hand-rail
10.19. Removal and installation of facing of a tunnel of a floor
10.20. Removal and installation of the panel of fastening of a radio receiver
10.21. Removal and installation of the panel of devices
10.22. A heater
10.23. Replacement of a windscreen and glasses of a door of a back and боковины
10.24. Care of a body
10.25. Anticorrosive protection of a body
10.26. Possible malfunctions of a body, their reason and ways of elimination
11. Variants of execution of the car
12. Care of the car
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Appendices
 















10-8-snyatie-ustanovka-i-regulirovka-zamka-i-privoda-zamka-kapota.html

10.8. Removal, installation and adjustment of the lock and a drive of the lock of a cowl

It be required to you: keys «on 8», «on 13», пассатижи, a screw-driver.
1. Open a cowl.
2. Turn out bolts of fastening of the lock.
3. Raise the lock and straighten the unbent end of draught of a drive пассатижами.
4. Take away the plug on draught downwards and...
5.... Disconnect draught from the lock.
6. After return installation of the lock if necessary adjust length of draught, bending it in other place.
7. To remove draught of a drive of the lock, turn out a bolt скобы fastenings of a cover of draught.
8. Remove plastic скобы, крепящие a cover to a body.
9. From within salon turn out an axis of the handle of a drive of the lock of a cowl.
10. Remove the handle.
11. Remove the plastic plug and draught in gathering with a cover, having extended it through an aperture in a board передка bodies in salon.
12. Will put the lock of a cowl and its drive in an order, the return to removal.
13. After installation adjust lock position by its moving concerning a body (fastening bolts for descriptive reasons are not shown). Correctly put lock should be locked accurately without blow at release a cowl from height about 15 sm and easily open a drive.
14. After adjustment of position of the lock tighten bolts of its fastening.

«The previous page
10.7. Removal and cowl installation
The following page»
10.9. A back door