Chevrolet-Niva
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. The engine
5. Transmission
6. A running gear
7. A steering
8. Brake system
9. An electric equipment
10. A body
10.1. Features of a design
10.2. Removal and installation of lobbies Lockers
10.3. Removal and installation of forward wings
10.4. Removal and installation of decorative overlays on forward wings and doors
10.5. Replacement of buffers
10.6. Removal and installation of facing of a radiator
10.7. Removal and cowl installation
10.8. Removal, installation and adjustment of the lock and a drive of the lock of a cowl
10.9. A back door
10.10. Forward doors
10.11. Back doors
10.12. Removal and installation of a cover of the hatch of a fuel tank
10.13. Seats
10.14. Removal of upholsteries of salon
10.15. Replacement of seat belts
10.16. Mirrors
10.17. Replacement противосолнечных peaks
10.18. Replacement of hand-rail
10.19. Removal and installation of facing of a tunnel of a floor
10.20. Removal and installation of the panel of fastening of a radio receiver
10.21. Removal and installation of the panel of devices
10.22. A heater
10.23. Replacement of a windscreen and glasses of a door of a back and боковины
10.24. Care of a body
10.25. Anticorrosive protection of a body
10.26. Possible malfunctions of a body, their reason and ways of elimination
11. Variants of execution of the car
12. Care of the car
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Appendices
 













10-2-snyatie-i-ustanovka-perednikh-podkrylkov.html

10.2. Removal and installation of lobbies Lockers

For protection against a dirt in niches of forward wheels of the car are established plastic подкрылки, two-piece.
It be required to you: a key «on 10», a screw-driver, a key for nuts of wheels.

1. Remove a corresponding wheel.
2. Turn out fastening screws подкрылка to lateral and...
3.... To the bottom part of the forward buffer.
4. Turn away a nut of the top fastening подкрылка and...
5.... Remove a forward part подкрылка.
6. Turn out screws of fastening of a mudguard.
7. Turn out the screw of back fastening подкрылка and...
8.... Remove a back part подкрылка.
9. Establish parts подкрылка in an order, the return to removal.

       GOOD ADVICE
To prevent corrosion, before assemblage put on fastening details подкрылка консистентную greasing.

«The previous page
10.1. Features of a design
The following page»
10.3. Removal and installation of forward wings