Chevrolet-Niva
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. The engine
5. Transmission
6. A running gear
7. A steering
8. Brake system
9. An electric equipment
10. A body
10.1. Features of a design
10.2. Removal and installation of lobbies Lockers
10.3. Removal and installation of forward wings
10.4. Removal and installation of decorative overlays on forward wings and doors
10.5. Replacement of buffers
10.6. Removal and installation of facing of a radiator
10.7. Removal and cowl installation
10.8. Removal, installation and adjustment of the lock and a drive of the lock of a cowl
10.9. A back door
10.10. Forward doors
10.11. Back doors
10.12. Removal and installation of a cover of the hatch of a fuel tank
10.13. Seats
10.14. Removal of upholsteries of salon
10.15. Replacement of seat belts
10.16. Mirrors
10.17. Replacement противосолнечных peaks
10.18. Replacement of hand-rail
10.19. Removal and installation of facing of a tunnel of a floor
10.20. Removal and installation of the panel of fastening of a radio receiver
10.21. Removal and installation of the panel of devices
10.22. A heater
10.23. Replacement of a windscreen and glasses of a door of a back and боковины
10.24. Care of a body
10.25. Anticorrosive protection of a body
10.26. Possible malfunctions of a body, their reason and ways of elimination
11. Variants of execution of the car
12. Care of the car
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Appendices
 















10-21-snyatie-i-ustanovka-paneli-priborov.html

10.21. Removal and installation of the panel of devices

It be required to you: keys «on 10», «on 13», screw-drivers with a flat and crosswise edge.
1. Disconnect a wire from the plug "minus" of the storage battery.
2. Turn out five screws of a facing casing of a steering column and...
3.... Remove the top and bottom parts of a casing.
4. Remove a steering wheel (Removal and steering wheel installation »see«).
5. Remove подрулевые switches (Replacement подрулевого the switch »see«).
6. Remove the switch (lock) of ignition (Removal and installation of the switch of ignition »see«).
7. Remove a shaft of a steering column («Replacement of a shaft of a steering column» see).
8. Remove the panel of fastening of a radio receiver (Removal and installation of the panel of fastening of a radio receiver »see«).
9. Remove facing of a tunnel of a floor (Removal and installation of facing of a tunnel of a floor »see«).
10. Remove upholsteries of forward racks («Removal of upholsteries of salon» see).

       GOOD ADVICE
Probably, at installation of the panel of devices new collars of fastening of plaits of wires as in their some places it is easier to cut will be necessary for you, than to separate.
At separation колодок plaits of wires mark them rather each other. It will facilitate work at installation of the panel of devices. Free pad mark separately.

11. Disconnect колодку a plait of wires of the panel of the devices, located around an accelerator pedal.
12. Disconnect pad plaits of wires from the switch of a stoplight and...
13.... The block of management of automobile anticreeping system.
14. Disconnect three pad a plait of wires of the panel of the devices, located for the assembly block.
15. Turn out the screw and disconnect from a body "a mass" wire.
16. Open a cowl.
17. Remove a facing overlay of a wind window and the screen wiper mechanism (Removal, installation and repair of a screen wiper of a wind window »see«).
18. Remove the filter of giving of external air («Replacement of the filter of air arriving in salon» see).
19. Turn out screws of fastening of the case of an air inlet.
20. Merge a part of a cooling liquid («Replacement of a cooling liquid» see) and disconnect branch pipes of a radiator of a heater.
21. Turn out a bolt of fastening of a cross-beam of the panel to a rack.
22. Turn out a bolt of fastening of a rack to an arm and...
23.... Remove a cross-beam rack.
24. Turn out four bolts of fastening of a cross-beam of the panel of devices to an arm of a steering shaft.
25. Turn out bolts of lateral fastenings of the panel of devices (at the left and on the right).
26. Remove an insert of the panel of devices (Replacement of a windscreen and glasses of a door of a back and боковины »see«).
27. Turn out the bolts located in a forward part of the panel of devices along the bottom edge of a windscreen.
28. Take a forward air line of heating of salon.
29. Remove the panel of devices in gathering with a heater and a plait of wires.
30. Establish the panel of devices and all removed details in an order, the return to removal. Add a liquid in cooling system («Replacement of a cooling liquid» see).

«The previous page
10.20. Removal and installation of the panel of fastening of a radio receiver
The following page»
10.22. A heater