9-24-zamena-datchikov-i-vyklyuchatelejj.html
9.24. Replacement of gauges and switches Replacement of the gauge of an alarm lamp of emergency pressure drop of oil
The gauge of an alarm lamp of emergency pressure drop of oil is established in an adapter screwed in an oil highway of the block of cylinders on the left side.
It be required to you: keys «on 21», «on 22».
|
|
|
|
1. Remove from the gauge a protective cover and disconnect from it a wire.
|
2. Keeping a key an adapter...
|
|
|
|
3.... Turn out the gauge.
|
|
4. Establish the gauge in an order, the return to removal.
|
Replacement of the gauge of the index of temperature of a cooling liquid
The gauge of the index of temperature of a cooling liquid will screw in an aperture of a head of the block of cylinders on the left side.
The key «on 21» is required to you.
|
|
|
|
1. Remove a protective cover and disconnect a wire from the gauge.
|
2. Ослабьте an inhaling of the gauge and...
|
|
|
|
3.... Turn out the gauge from a head of the block of cylinders.
|
|
4. Establish the gauge in an order, the return to removal.
|
|
GOOD ADVICE
For the best tightness grease a gauge carving with a thin layer of hermetic.
|
Replacement of the switch of light of a backing
The switch of light of a backing is established on a back cover of a transmission.
The key «on 22» is required to you.
|
|
|
|
1. Disconnect from the gauge колодку a plait of wires and...
|
2.... Turn out the gauge.
|
|
THE PREVENTION
Do not lose the copper sealing ring established under the gauge. At gauge replacement rearrange this ring on the new gauge.
|
|
3. Establish the gauge in an order, the return to removal.
|
Replacement of the switch of a stoplight
The stoplight switch is located under the panel of devices on an arm of pedal knot.
The key «on 22» is required to you.
|
1. Disconnect from the gauge pad wires.
|
|
|
|
|
2. Ослабьте an inhaling of a fixing nut and...
|
3.... Turn out the gauge from an arm of the pedal block.
|
|
4. Establish the gauge in an order, the return to removal.
|
|
5. After installation adjust gauge position, rolling or turning out it from an arm so that stoplights in back lanterns lighted up at moving of a pedal of a brake approximately on 0,5 see do not forget to tighten fixing nut of the gauge.
|
Replacement of the switch of a control lamp of inclusion of a lay brake
The switch of a control lamp of inclusion of a lay brake is established under facing of a tunnel of a floor around the lever of a lay brake.
The screw-driver is required to you.
|
1. Remove facing of a tunnel of a floor (Removal and installation of facing of a tunnel of a floor »see«).
|
|
|
|
|
2. Turn out the screw of fastening of the switch to an arm of the lever of a lay brake.
|
3. Remove the switch and...
|
|
|
|
4.... Disconnect from it колодку a plait of wires.
|
|
5. Establish the switch and facing of a tunnel of a floor in an order, the return to removal.
|
|