Chevrolet-Niva
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. The engine
4.1. Features of a design
4.2. A good advice
4.3. Removal and installation of a decorative casing of the engine
4.4. Removal and installation of protection oil crankcase and an engine mudguard
4.5. Replacement of a cooling liquid
4.6. Oil replacement in the engine and the oil filter
4.7. Clearing of system of ventilation crankcase
4.8. Replacement of support of a suspension bracket of the power unit
4.9. Installation of the piston of the fourth cylinder in position ВМТ of a step of compression
4.10. Check and installation of phases timing on labels
4.11. Replacement натяжителя chains of a drive of a camshaft
4.12. Replacement успокоителя chains of a drive of a camshaft
4.13. Boot replacement натяжителя chains of a drive of a camshaft
4.14. Replacement of a chain of a drive of a camshaft
4.15. Replacement of hydrosupport of levers of a drive of valves
4.16. Removal, installation and дефектовка a flywheel
4.17. Replacement of the forward bearing of a primary shaft of a transmission
4.18. Replacement of details of consolidation of the engine
4.19. Camshaft replacement
4.20. A head of the block of cylinders
4.21. Removal and engine installation
4.22. Engine repair
4.23. Greasing system
4.24. Cooling system
4.25. System of release of the fulfilled gases
4.26. The power supply system
4.27. Possible malfunctions of the engine, their reason and ways of elimination
5. Transmission
6. A running gear
7. A steering
8. Brake system
9. An electric equipment
10. A body
11. Variants of execution of the car
12. Care of the car
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Appendices
 













4-11-zamena-natyazhitelya-cepi-privoda-raspredelitelnogo-vala.html

4.11. Replacement натяжителя chains of a drive of a camshaft

Натяжитель pruzhinno-hydraulic type remove for replacement at failure, and also at replacement of details of a drive газораспределительного the mechanism and a head of the block of cylinders.
It be required to you: a key «on 10», a screw-driver.
1. For simplification of access to натяжителю ослабьте a collar of fastening of the right part of a branch pipe of air intake to throttle knot...
2.... Turn out a bolt of fastening of a branch pipe and...
3.... Having disconnected the right part of a branch pipe from throttle knot, raise it upwards.
4. Turn away a nut of a tube of a supply of oil to натяжителю...
5.... Disconnect a tube from натяжителя and take her aside.
6. Turn on two nuts of fastening натяжителя to a head of the block of cylinders and...
7.... Take out it from a nest, trying not to damage the lining located under it.

GOOD ADVICE
We recommend натяжителя to replace at each removal a lining new. Before installation grease it from both parties with a thin layer of hermetic.

8. Establish натяжитель in an order, the return to removal, having checked up cleanliness of a drainage aperture in its case.


«The previous page
4.10. Check and installation of phases timing on labels
The following page»
4.12. Replacement успокоителя chains of a drive of a camshaft