Chevrolet-Niva
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. The engine
4.1. Features of a design
4.2. A good advice
4.3. Removal and installation of a decorative casing of the engine
4.4. Removal and installation of protection oil crankcase and an engine mudguard
4.5. Replacement of a cooling liquid
4.6. Oil replacement in the engine and the oil filter
4.7. Clearing of system of ventilation crankcase
4.8. Replacement of support of a suspension bracket of the power unit
4.9. Installation of the piston of the fourth cylinder in position ВМТ of a step of compression
4.10. Check and installation of phases timing on labels
4.11. Replacement натяжителя chains of a drive of a camshaft
4.12. Replacement успокоителя chains of a drive of a camshaft
4.13. Boot replacement натяжителя chains of a drive of a camshaft
4.14. Replacement of a chain of a drive of a camshaft
4.15. Replacement of hydrosupport of levers of a drive of valves
4.16. Removal, installation and дефектовка a flywheel
4.17. Replacement of the forward bearing of a primary shaft of a transmission
4.18. Replacement of details of consolidation of the engine
4.19. Camshaft replacement
4.20. A head of the block of cylinders
4.21. Removal and engine installation
4.22. Engine repair
4.23. Greasing system
4.24. Cooling system
4.25. System of release of the fulfilled gases
4.26. The power supply system
4.27. Possible malfunctions of the engine, their reason and ways of elimination
5. Transmission
6. A running gear
7. A steering
8. Brake system
9. An electric equipment
10. A body
11. Variants of execution of the car
12. Care of the car
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Appendices
 















4-3-snyatie-i-ustanovka-dekorativnogo-kozhukha-dvigatelya.html

4.3. Removal and installation of a decorative casing of the engine

For improvement of appearance of a motor compartment, and also for noise level decrease on the car engine the decorative plastic casing is established. At performance of the majority of works on repair and engine service this casing is necessary for removing.
The decorative casing established on the car, is fixed by four rubber clamps.
1. For casing removal hook a screw-driver edge of a hat of a clamp and...
2.... Take a clamp from a casing aperture, having removed it from an arm hairpin.
3. Similarly take other three clamps and remove a decorative casing.

THE NOTE
It is possible to remove a decorative casing and without preliminary extraction of clamps, having pulled upwards for casing edges.
However for return installation of a casing clamps should be taken preliminary from its apertures.

4. Establish a decorative casing in an order, the return to removal.


«The previous page
4.2. A good advice
The following page»
4.4. Removal and installation of protection oil crankcase and an engine mudguard